If you are starting from scratch, make a new project and create a new sequence. If you are adding leader to an existing sequence, open your project and select your sequence. Using Standard Leader in Adobe Premiere Pro Be sure to choose the leader settings that best match your project settings. They can be found in the same location as the standard head leaders: FVCentral > Support > Leader. Pre-existing tail pops to all HD specifications and frame rates can be downloaded from the server and used on your projects. It should be placed after the last frame of your project. The tail pop is a 4 second long video that has a pop at 2 seconds. Tail pops are used at the end of your project to detect if there has been any sync drift in your film. It is highly recommended to begin new projects with standard leader already in the timeline, but leader can be placed into existing projects. Use the following table to choose the leader settings that best match your project settings. They can be found at FVCentral > Support > Leader. Pre-existing countdown leader to all the specifications and frame rates can be downloaded from the server and used on your projects. 01:00:00:00 – your movie begins, no picture or sound should start before this.00:58:30:00 – 1 minute of color bars and tone.The following standards should be followed when using the leader: and serves as a standard for color, sound level, and sync during projection. Standard head leader is used through the steps of picture edit, sound edit, sound mix, color correction, layback etc. Download CalArts Leaders Standard Leader Basics
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |